What causes the overcurrent alarm in the 80kw high-frequency induction heating power supply?

This morning, we received a call from a customer saying that his 80kw high-frequency induction heating power supply had an overcurrent alarm and asked us what to do. Our salesman told him the solution. He just called and said that the problem has been solved. Thank you very much. So what is the reason for the overcurrent alarm in the 80kw high-frequency induction heating power supply, and what are the solutions? Don't worry, I will tell you slowly.

The reasons and solutions for overcurrent alarms in equipment are as follows:

1. The sensor has poor contact or short circuit. Therefore, we should check the sensor.

2. The contact point of the AC contactor is in poor contact. This also needs to be checked. If the contact is poor, the AC contactor needs to be replaced with a new one.

3. The number of sensor turns is too many or too few. This will generally not occur. Because the sensors used by customers generally match the equipment. If this is the reason, the sensor must be remade and the number of sensor turns reduced. So never change the sensor without permission.

4. Turn on the external power connector. Just check the external power supply.

5. The high-frequency cable has poor contact. We need to check the high-frequency cable.

6. The driver board connector is not firmly inserted. Check the driver board plug. If it is not plugged in properly, you need to plug it in again and make sure it is firmly plugged in.

Well, after seeing this, I think you already know the reasons for the overcurrent alarm in the 80kw high-frequency induction heating power supply. The current alarm will cause the equipment to stop working, which greatly ensures the service life of the equipment and avoids damage to the equipment. This is a major feature of our equipment.