What are the key points for proper use and maintenance of sensors in medium frequency induction heating equipment?

The working principle of medium frequency induction heating equipment is to place a metal cylinder in an induction coil with alternating medium frequency current. The metal cylinder is not in direct contact with the induction coil. The temperature of the energized coil itself is already very low, but the surface of the cylinder is heated. to reddening and even melting, and the speed of reddening and melting can be achieved by adjusting the frequency and the strength of the current. Therefore, the induction coil (inductor) is an important part of the medium frequency induction heating equipment. Today, the editor will tell you what should you pay attention to during the use and maintenance of the inductor?

The sensor is a kind of precision tooling that needs to be made according to the specifications of the workpiece. It is expensive and has a lot of technical content. Therefore, it must be used carefully and maintained carefully. The following aspects should be paid attention to during use and maintenance:

1) When multiple sensors are used at one point of use, there must be a sensor storage rack and be numbered.

2) When installing the sensor, the clamping mechanism such as the compression bolt or eccentric chuck must be tightened, and the positioning block fixing screws must also be checked frequently to ensure they cannot become loose.

3) Water connection is the key. Do not make mistakes or omissions. Only allow power on after confirming that water is available.

4) After the sensor is used, iron filings and oil must be wiped off before it can be put back into the storage rack. Sometimes oil dirt and iron filings combine to form a hard shell on the magnet of the crankshaft sensor, which can cause a short circuit, so you must pay attention.

5) Before use, the sensor of the medium frequency induction heating equipment should be wiped on the clean contact surface with fine gauze. During installation, it should be handled with care to prevent bumps and deformation.

6) If it is found that the position of the magnet has changed or other accessories are loose, the sensor must be adjusted before use.

7) The gap between the effective ring and the workpiece must be checked regularly according to the requirements of different sensors. The deformed effective ring must be adjusted before use.

The production of inductors must be carried out according to the specifications of the workpiece. Zhengzhou Gou's has been engaged in the production and sales of medium frequency induction heating equipment for fifteen years, and has accumulated rich experience in the production of inductors. If you want to manufacture inductors, please call us.