Medium frequency induction heating furnace for Wushuang titanium alloy diathermy

Introduction to the advantages of medium frequency induction heating furnace

1. The induction heating speed is fast and the efficiency is high

2. Energy saving and low cost

3. Multiple workpieces can be welded at the same time, which greatly improves the welding efficiency

4. Small oxidation area

5. Uniform heating, no lack of welding and missing solder joints.

6. The appearance of the workpiece after welding is exquisite and firm

7. Efficient and fast welding teeth, 1-5 seconds per tooth.

8. Good repeatability, each tooth has good repeatability.

9. Fast and uniform heating, which can effectively prevent embrittlement and fracture caused by partial overheating of the saw teeth; it can also prevent tooth loss and other undesirable phenomena caused by incomplete penetration.

10. It can weld high-performance, high-hardness saw blades, which cannot be welded by resistance welding.

11. Less power consumption

Application of medium frequency induction heating furnace

1. All kinds of shafts are quenched, the hardened layer is 1.5-3mm, the diameter is Φ10mm-250mm, all kinds of inner holes are quenched - the inner wall of the pump tube is quenched, the inner wall of the gear is quenched, etc.

2. Φ5-Φ12 wire annealing - pipe annealing, titanium alloy annealing equipment - steel plate annealing, etc.

3. Welding cross drill bits of various drill bits, straight drill bits, etc.

4. Bars below Φ25 are diathermic, and the speed is much faster than that of silicon controlled rectifiers. Φ60mm-Φ100mm bar diathermy-round steel diathermy, titanium alloy diathermy equipment.

5. Various chains, sprocket heat treatment.

6. Quenching gears with a diameter of 3 meters and a weight of 80 tons in Anshan Iron and Steel Co., Ltd

7. The Φ1016mm steel pipe with a thickness of 17.5mm was used for the Hanjiang Bridge to be heated to 1000 degrees for hot bending

8. All kinds of steel pipes are heated and necked and formed

9. Machine tool guide rail gears and sprockets are quenched

10. All kinds of elbows are heated to expand and shrink

11. Annealing of Φ50mm thick 3mm stainless steel tube