Bolt end heating by high frequency induction heating power supply

Now, what equipment are you using for diathermy heat treatment of workpieces? The high-frequency induction heating power supply produced by Zhengzhou Gou's has perfect functions and is easy to operate. It is a good equipment for diathermy workpieces. A Macedonian customer once purchased two sets of 60kw high-frequency induction heating power supplies to perform diathermy heat treatment on the bolt ends, and the effect is quite good. Our equipment not only sells well in China, but also sells to Indonesia, Malaysia, Vietnam, Mexico, South Africa, Brazil and other countries and regions.

The Macedonian customer wants to perform diathermy heat treatment on the bolt ends. The diameter of the workpiece is 10mm, and two or three bolts need to be heated at a time. After calculation and analysis, we recommended a 60kw high-frequency induction heating power supply for them. Whether it is the heating speed or the diathermy effect, the customer all feel good.

Advantages of high frequency induction heating power supply

1. There is no need to heat the workpiece as a whole, but local heating can be carried out selectively, so the power consumption is small and the deformation of the workpiece is small. 

2. The surface hardened layer can be regulated by adjusting the operating frequency and power of the equipment as required. As a result, the martensite structure of the hardened layer is finer, and the hardness, strength and toughness are relatively high.

3. The workpiece after heat treatment by induction heating has a thicker tough area under the surface hard layer, which has better compressive internal stress, so that the fatigue resistance and breaking capacity of the workpiece are higher. 

4. High utilization rate of electric energy, environmental protection and energy saving, safety and reliability, good working conditions for workers, advocated by the state.

5. The heating equipment is easy to install on the production line, easy to realize mechanization and automation, easy to manage, can effectively reduce transportation, save manpower, and improve production efficiency.

6. The heating speed is fast, which can make the workpiece reach the required temperature in a short period of time, and the heating speed is uniform. As a result, the surface oxidation and decarburization of the workpiece are lighter, and most workpieces do not require gas protection.

7. Easy to use, easy to operate, and can be started or stopped at any time. And without preheating.

8. It can be operated manually, semi-automatically and fully automatically, it can work continuously for a long time, or it can be used at random when it is used. It is conducive to the use of equipment during the preferential period of low power supply price.