Bar heating by high frequency induction heating power supply

Are you still worried about the overheating of large-size bars? Now, the high-frequency induction heating power newly developed by Zhengzhou Gou's can diathermy large-sized bars. This equipment can not only diathermy bars, but also quench, weld, smelt, anneal and other heat treatments for workpieces. , is widely used.

Features of high frequency induction heating power supply

1. Under the same conditions, it has twice the power saving effect of traditional electronic tube high-frequency heating equipment.

2. With constant current and constant power control functions, it can greatly optimize the heating process of metals, realize efficient and rapid heating, and give full play to the superiority of the product.

3. With 99% full load design, it can work continuously for 24 hours.

4. It has heating-insulation-cooling three-stage function setting, which is conducive to improving the heating quality and heating cycle, and simplifying manual operation.

5. Select the power supply according to the power and frequency. The higher the frequency, the shallower the heating depth, and the lower the frequency, the better the heat permeability.

6. The company adopts MOSFET, IGBT power devices and unique frequency conversion technology to run stably and provide higher reliability and durability.

Advantages of high frequency induction heating power supply

1. Fast heating speed, uniform heating (speed can be adjusted and controlled).

2. Easy to install, just connect the power supply, induction coil and water inlet and outlet pipes; small size, light weight, easy to use.

3. The operation is simple and can be learned in a few minutes

4. Eliminate high voltage, avoid the step-up transformer that generates nearly 10,000 volts of high voltage, and the safety is very high.

5. Quick start, heating can be started after water and electricity are turned on.5. Quick start, heating can be started after water and electricity are turned on.

6. Wide heating, can heat all kinds of metal workpieces (change the detachable induction coil according to the different working switches).

7. Less power consumption, about 70% less power than old-fashioned tube high-frequency equipment, the smaller the workpiece, the less power consumption.

8. Full protection, with alarm indications such as overvoltage, overcurrent, overheating, water shortage, etc., and automatic control and protection.

9. The effect is good, the heating is very uniform, the temperature rises quickly, the oxide layer is less, and there is no waste product after heating.

10. The temperature is controllable, and the heating temperature of the workpiece can be controlled by setting the heating time, so that the heating temperature can be controlled to a technical point.